WifiCar NodeMCU Motor Shield View larger

WifiCar NodeMCU Motor Shield

WIR-00117A1

24 Items

In Stock

R44.55

More info

This WiFi RC smart car is designed and developed based on ESP-12F from ESP8266, which can be controlled by mobile, PC. This is motor shield only, you maybe need nodemcu board and a remote car chassis to drive as kit.

Package ONLY includes the Motor shield, NOT including the nodemcu board.

Features:

  • Support to drive two channels of DC motors via screw terminals.
  • Motor power supply (VM): 4.5V ~ 36V, can be a separate power supply;
  • Control power (VIN): 4.5V ~ 9V (10VMAX), can be powered separately;
  • Module provides short-circuit sub (short the VM and VIN), you can easily use one power (which must be 4.5V ~ 9V) simultaneously drive and control the motor; Otherwise your nodemcu will be burned.
  • Logic Operating current Iess: 60mA (Vi = L), 22mA (Vi = H);
  • Working current driving portion Io: 1.2A;
  • Maximum power dissipation: 4W (T = 90 )
  • Control signal input level: High: 2.3VVIHVIN; Low: -0.3VVIL1.5V
  • Working temperature: -25 ~ + 125
  • Drive Type: Dual high-power H-bridge driver
  • Support wireless 802.11 b / g / n standards;
  • Support STA / AP / STA + AP three operating modes;
  • Built-in TCP / IP protocol stack to support multiple TCP Client connection (5 MAX);
  • D0 ~ D8, SD1 ~ SD3: used as GPIO, PWM, IIC, etc., port driver capability 15mA;
  • AD0: 1 Road ADC;
  • Current: continuous transmission: 70mA (200mA MAX), Standby: <200uA;
  • Transfer rate: 110-460800bps;
  • Support UART / GPIO data communication interface;
  • Remote firmware upgrade (OTA);
  • Smart Link supports intelligent networking capabilities.
  • It can work at many modes, such as:AP mode and STA mode.

9 other products in the same category: