LDR Relay Breakout Board

LDR Relay Breakout Board

Backorder (Out of Stock)
Tax included

  Secure Checkout

Pay via Card, Zapper or Bank Transfer.

  Free Delivery over R750

To your door delivery.

  Guaranteed Customer Support

Need help? See our Support Page.



This neat little board is GREAT for automatic light sensitive projects that don't require any micro controllers.
A very good idea idea would be to attach a light to the relay side, and leave the LDR in the a place where it will recieve light,
then simply adjust the potentiometer to let the light turn on or off when the Sunsets or Rises. Now you have your very own,
automatic outside light. This principle can be applied to almost any device that you might want to turn on or off in relation to a light source.

Uses a photosensitive resistor inductor to measure intensity of light. With the use of the high quality relay you can directly control the load of an AC or DC device.
Maximum Ratings: AC 0V-250V@10A OR DC 0V-30V@10A;
The sensitivity of the light to trigger the relay can be adjusted with an onboard poteniometer.
Reverse polarity protected
Power indicator LED(red) & Relay Status Indicator LED(blue)
Dimensions: 50mm x30m x 18mm
LDR wire length: 30cm

Working current: when using 5V, the device will draw below 90mA
   when using 12V, the device will draw below 50mA
   when using 24V, the device will draw below 30mA

Working temperature: Recommended temp range is -20 <-> 60 degrees Celsius (Maximum is -20 <-> 70 degrees Celsius)
Load capacity:
   Normally open terminal  0-30V @ 10A DC OR  0-250V @10A AC
   Normally closed terminal:  0-28V @ 10A DC OR 0-125V @ 10A AC

Please note that sometimes the picture may not always be exactly as what the product looks like.

Product Details

Product added to wishlist