Secure Checkout
Pay via Card, Zapper or Bank Transfer.
Free Delivery over R750
To your door delivery. Main Centres Only.
Guaranteed Customer Support
Need help? See our Support Page.
Transmitter and receiver kit
Transmit power: 11dbm
Emission current: 10MA
Launch Rate: up to 10KB / S
Working voltage: DC 3V-24V
Each module has a unique ID address code. The four key codes for all modules K1-K4 are the same.
RX480-E4 Working voltage: DC3.3 ~ 5V
Quiescent current: ≤5mA
Output current: 10 mA
Working frequency: 433MHz
Receiving sensitivity: -108dB
Operating temperature: -25 ~ 75
Operating modes: instantaneous mode, self-locking (4-channel switching mode), interlocking Output: 4 CMOS level signal corresponding remote ABCD 4 buttons.
Pins instruction
GND: Ground or negative + V: DC3.3 ~ 5V
input D0: data output D1: data output D2: data output D3: data output VT: output
How to Match Transmitters and Receivers
1. Delete Existing Data: Press Learning Button (on receiver) 8 times. Response: LED flashes 7 times.
2. Learn the remote code: Press the Learn button (on the receiver) once, twice or three times (see below). LED lights up: learning mode is activated. Press any button on the remote control. LED flashes three times: learning completed successfully.
3. Test: After the above operation, the receiver board can be controlled by the remote control. More transmitters with different IDs can be learned and stored additionally, starting with step 2 . There can be different modes of blending. Button to use (set mode and start pairing process): Press once: Jog mode (momentary mode) Press twice: Self-locking mode (4-channel switching mode) Press three times: Interlock mode (selected channel activated and cleared, if another channel became active)
