light sanding between layers will give a smooth exceptional finish.
It has a very high fill and covering capacity
- A simple, fast and time-saving process
- Fast drying
- Suitable for wet and dry sanding
- Over-paintable with water-based and solvent-based paints
- Resistant to silicone remover
- Perfect adhesion on steel, aluminum, polyester putty, old paintwork
- Suitable on the following plastics: - PLA, PC, PVC, ABS, PA, SAN, PU, UP, EP, PETG, NYLON
- Chromate free
Air: 60 minutes at 20°
The drying time depends on the environmental temperature, layer thickness and humidity
It is essential to wear a respirator mask!
Before use, shake well for at least 2 minutes. The surface must be thoroughly cleaned and slightly sanded. The surface must be free from grease, dust-free and dry. Clean with silicone remover. Carry out a spray test. Apply 2-3 layers with a layer thickness of 70-80µ. Flash off between layers 2-3 minutes